Rally manufacturers to introduce you to a simple tensile machine maintenance methods which:
  Check the site regularly jaws screw, if found loose, tighten timely;
  Inlaid steel liner sliding surface in contact with the dovetail groove on the surface of the liner should be kept clean, regularly coated with a thin layer of MoS2 (molybdenum disulfide) grease;
  Check the drive sprocket regularly and, if found loose, please re-tensioning the tension wheel.
  Maintenance oil source
  Check regularly Rally and oil spill at the source has a place, if there is leakage, seal rings should be replaced, or a combination pad;
  Depending on the period of use of the machine and the oil, oil filter and the regular replacement of the filter, replace the hydraulic oil.
  For a long time do not do the test, pay attention to pull off the power source. If the machine is in standby mode, the switch should hit the "load" file, because if you switch hit "rewind" position, solenoid valve has been energized, it will affect the life of the device.
  Control system maintenance
  Periodic inspection panel of the controller cable is good contact, if loose, should be tightened;
  After the test if a longer period of time without the machine, turn off the controller and the computer;
  Interface controller for the correspondence, inserted in the wrong connector may cause damage to the equipment;
  Interface plug on the controller must be switched off power to the controller.
  Fifth, according to the time machine and oil usage, regular replacement of oil filter and filter, hydraulic oil is changed periodically checks Rally and oil spill at the source has a place, if there is leakage, the seal should be replaced rings or combination pad.